I finished most of the hardware except the electronics last night.
Everything fits and sits perfectly, BUT i still want to fit in a pot a toggleswitch, four servo outs and 8LEDs and the space is extremely limited already.
On the last photo you can see whats inside the box.
The MIDI interface is already installed on the small PCB-
I cut out all PCBs with a jigsaw, and grinded the edges so that nothing has contact with the enclosure.
The ESC will be soldered onto the MIDI-board and fits right into the squared hole in the PCB.
All contacts will be soldered to the PCB, and the motor gets power over this PCB too.
If there will be enough space left, i will use small plugs for the motors power line, if not, i will solder it directly to the PCB.